To fully enjoy the outdoor jacuzzi and ensure the water stays at its best for you and future guests, it's important to use it properly.
Always shower before using the jacuzzi, and avoid putting anything in the water, such as shampoo, soap, or food.
It's important to rinse of all soap and shampoo before entering, otherwise the PH levels will change fast.
The spa is a warm, closed water system, and when several people use it the water is quickly affected by sweat, skin residue, cosmetics, etc. To keep the water clean, clear and safe for your entire stay, it’s important to follow these simple steps after bathing.
The green “SpaFrog” cartridge should be taken out while you are bathing and placed back in the water before closing the lid.
The red water sensor must always remain in the jacuzzi and should never be removed.
Find the box labeled “1 – Oxy”.
Pour the entire contents into the jacuzzi.
Leave the lid open.
Start Jet 1 and Jet 2.
Let the jets run until they stop automatically (about 15 minutes).
Then close the lid.
To open the cover:
From left to right
Put it on the right side:
Grab the black steel bar, and lift over to right:
To close:
Lift tab before moving everything back to left
Keep the jacuzzi on and at the set temperature even when not in use for optimal water circulation.
The jacuzzi is equipped with a wireless water sensor that monitors water quality. Keep it in the water at all times.
For hygiene, we use a bromine generator and the green "spa frog". Take out the "spafrog" when bathing, put it upside down. And put Spafrog back in the jacuzzi before closing/putting on cover.
Spafrog: Up side down, outside the spa, when bathing.
Put it back in the water before closing the cover.
After use, make sure to put the cover back on to maintain water cleanliness and temperature. Failing to put the cover back on can lead to the water freezing, potentially causing damage to the jacuzzi.
To use the sauna, use the power dial on the heating unit to turn the system on. Set the desired temperature and and timer, using the timer dial. You can adjust the timer settings to schedule how long the sauna will run and shut down, ensuring it is ready when you need it. Make sure to turned off the sauna after usage.
The Left dial controls the amount of power/heat put at 90%
The right dial controls the timer. If you go for a ski trip for 4 hours you turn the dial to the black area and the number 2.
The sauna starts heating after 2 hours. And the Sauna is hot after 1-2 ours. Starts heating when the timer reach the white numbers.
